2.4 KiB
MatCat RC Car
This is the official repository for the MatCat RC Car, an RC car designed to be 3D printed. I designed this car primarily as an exercise to improve my modeling skills, but also because I wanted a cool RC car to play with! The RC car is designed to be an all-purpose RC vehicle, the initial model is a rear wheel drive double wishbone suspension vehicle designed primarily for 'on road' driving, though a 4wd model is planned as well. The car is completely designed from scratch for 3D printing, the only non-printed parts are metric screws, ball bearings, and electronics. The vehicle is roughly 1:7 scale based on vehicle width compared to average vehicle widths, this would make this vehicle roughly on par with a small compact vehicle in scale. Please note any and all specificaions are subject to change as this is a work in progress.
Specifications
| Specification | Value |
|---|---|
| Scale | 1:7 |
| Wheelbase | 259mm (10.2") |
| Width | 247mm (9.7") |
| Length | 359mm (14.1") |
| Empty Weight (no battery) | TBD |
| Curb Weight | TBD |
| Stock Wheel size | 72mm diamater by 27mm width |
| Differential Ratio | 1.714 (7:12) |
| Transmission | Direct Drive, a gear box is planned with an initial 8:1 gear set |
| Motor | Random brushless motor from my parts bin, probably a 2200KV |
| ESC | Cheap 60A ebay / amazon ESC rated 2-3 cell |
| Steering Servo | Cheap 9G micro servo, probably not big enough, will change out if needed |
| Battery | 3S 2200mAh LIPO |